Media Notes: adultery to electrical and electronic products into Australia, in addition to the safe

Media Notes: adultery to electrical and electronic products into Australia, in addition to the safety labeling, but also should have EMC signs that c-tick mark. The purpose is to protect the radio frequency communication resources, the implementation of the system which is somewhat similar to the provisions of the European EMC directive. Therefore, self-declaration by the manufacturer / importer. However, before you apply for C-tick mark, must be tested according to the relevant CISPR standards. And want to endorsement by the Australian importer & reports. Australia ACA (Australian Commication Authority) shall be accepted, payment of the registration number.
Information appliances SAA certification required to submit a. Samples 2-4 2. Schematics (Please note parameters must, consistent with the specification plate) 3. Printed circuit layout, led 2012 component location diagram A line of electronic led 2012 products, are required to provide B if the electronic switches, dimmers and other electronic components have been certified 4 can not provide this. English manual (manual or trademark shall have the make, model, parameters, led 2012 the installation method and the necessary safety warnings) 5. Model Description difference (if there are multiple models led 2012 with the series, to be clearly spelled out the similarities and differences between the models. The statement must have the signature.) 6. Label / plate 7. Product installation diagram / exploded diagram (please specify each component part numbers and names.) 8. Key Parts (The list must have signature) A corresponding explosion in the following format and coding sequence diagram lists the parts; B each fill out a series of products, led 2012 if a component is only available on certain models, please indicate 9. Copy of the certificate of important safety-related components (refer to the "key parts list" requirements led 2012 to provide a certificate, and shall number parameters are consistent with the actual sample check on the certificate.) Third, the electrical cycle SAA SAA certification required the time required for authentication is 2-3 weeks, with specific time to see the situation of the factory, whether led 2012 with or without the test report and the readiness of the information may be. Fourth, the certification process of an electrical SAA, completing led 2012 the application form 2, send samples to test three products, product rectification (when the test failed) 4, the report issued five reports to assess six, five certificates issued, SAA testing standards with IEC and EN basically the same standard, but there are small differences. Therefore, led 2012 the test needs to be Australia differences write in the report. Paying led 2012 particular led 2012 attention to the pins have special requirements. Australia voltage single phase 240V, three phase 415V. The frequency of 50Hz welcome to contact the person in charge SAA certification; Ding 18,948,793,327 lamp SAA certification, energy saving lamps SAA certification, chandeliers SAA certification, nightlights SAA certification, advertising lights SAA certification, fluorescent SAA certification, wall SAA certification, SAA certification downlight lamps SAA certification, lawn SAA certification, LED lights SAA certification, SAA certification flashlight SAA certified power adapter SAA certification comment IMPORTANT: vigilance false winning information SINA Inc. All rights reserved